Icom UC-FR5000 Trunking / Networking Controller
This logic card adds trunking and networking capabilities to your IDAS repeater. The UC-FR5000 is an essential building-block for an IDAS system. Use with the following Icom repeaters:
- IC-FR5000 or IC-FR6000
- CY-5000 or CY-6000
- IAS-100DV or IAS-100DU
UC-FR5000 - basic building block to enable the following functions:
Single Site Trunking
Multi-Site Conventional + Voting (requires UC-FR5000 + CF-FR5000)
Once the UC-FR5000 controller is installed you can build on that configuration by adding the CF-FR5000 card into a slot on the UC-FR5000 logic board. Once added the repeater can operate in both single site trunking or multi-site conventional modes. This combination of enhancements also allows you to configure the repeater as a voting receiver. Voting receivers are usually located of poor coverage where the radio units cannot reach back to the transmitter. For more information see the IC-FR5000 or CY5000 repeater descriptions.
Multi-Site Trunking (requires UC-FR5000 + CF-FR5000MT)
With the UC-FR5000 controller installed, you can add the CF-FR5000MT card into a slot on the UC-FR5000 logic board and transform your repeater into a multi-site trunking repeater. For more information see the IC-FR5000 or CY5000 repeater descriptions.
Remote Repeater Management + RoIP Capabilities
The Icom UC-FR5000 logic board allows ethernet connectivity to the repeater for remote configuration, firmware updates, and conection to a PC running the Icom RC-FS10 software for a full RoIP (radio over internet protocol) solution. For more information on the RoIP function see RC-FS10 description.